English  Svenska 

Make a lace edge beanie

Today I'd like to show you a variation on my sewing pattern Sigge & Siri beanie. Adding lace to the beanie gives it a beautiful and romantic detail. And here's one way to do it!

I made this beanie in lovely college fabric from Elvelyckan Design. It is a perfect autumn beanie for those chilly days. 

Follow step 1-7 in the instructions booklet for the pattern, and then continue here. 
 

1.
While the beanie is sewn together at the top and with its right side in, take out stretch lace and pin it around the edge of the beanie. If there's a right side to the lace, it should be placed towards the beanie's wrong side/inside. 

 

1b.
Here I'm lifting and looking inside the beanie to see that the lace is even. I have chosen to have about 5-8 mm of the lace visible from the right side, and 1,5 cm on the inside. 

 

2.
Evert the beanie, now it is time to sew the lace. Sew from the right side of the beanie with a twin needle or wide zig zag, about 0,5-1 cm (1/4-3/8") from the edge. You are now sewing through two layers of fabric + the lace. 

 

3.
Press the seam you just sewed. And it's done!

You're welcome to comment below if you have any questions.


2 comments

  • Hej Monica! Tack snälla <3
    Här är det ett spetsband med stretch som jag använt :)
    Ursäkta sent svar!

    Caroline - Threads by Caroline
  • Hej vill först säga att du gör fantastiskt fina mössor ❤
    Jag undrar bara om det är spets resår som du använder? Eller är det vanliga spetsband?
    Hälsningar Monica Brinck

    Monica Brinck

Leave a comment

Please note, comments must be approved before they are published